4 WIRE RESISTIVE TOUCH SCREEN MUX BREAK OUT BOARD
About 4 WIRE RESISTIVE TOUCH SCREEN MUX BREAK OUT BAORD, CAN BE USED WITH ANY GRAPHICAL LCD IN THE BACK GROUNG, FEATURES AND USAGE VCC 5V OUT PUT: ANALOG BY TOUCHING THE SCREEN ON ANY GIVEN POINT, YOU WILL GET ANALOG VOLTAGE ON THE CORRESPONDING AXIS. “X” AXIS: MOVING FROM LEFT TO RIGHT THE VOLTAGE REMAINS CONSTANT AND MOVING FROM TOP TO BOTTOM THE VOLTAGE VARIES, (SELECT PIN SHOULD BE ACTIVE HEIGH). “Y” AXIS: MOVING FROM TOP TO BOTTOM THE VOLTAGE REMAINS CONSTANT AND MOVING FROM LEFT TO RIGHT THE VOLTAGE VARIES, (SELECT PIN SHOULD BE ACTIVE LOW). TO GET THE ACCURATE MEASURING AXIS OF X AND Y, FOLLOW THE INSTRUCTIONS BELOW: TO GET “Y” AXIS DATA OUTPUT: SELECT PIN SHOULD BE GROUND TO GET “X” AXIS DATA OUTPUT: SELECT PIN SHOULD BE TIED TO VCC TOGGLE SELECT PIN TO HEIGH AND LOW PULSES TO GET “X” & “Y” AXIS DATA CORRESPONDINGLY AND GET THE OUT PUT ANALOG VOLATES OF THE CORRESPONDING AXIS. INCLUSIONS 1 X 4 WIRE RESISTIVE TOUCH SCREEN MUX BREAK OUT BOARD
2.4 TFT LCD Touch Shield for uno & mega in chennai
3.2 262K Color Full-Angle LCD Module for Arduino Mega2560
This module is 3.2 inch TFT LCD with 262K color 480 x 320 resolutions. The controller of this LCD module is HX8357B, it supports 16-wires DataBus interface. Moreover, this module includes 5V~3.3V power conversion circuit and Level conversion circuit; This Module can Directly inserted into the Arduino Mega2560 Board, it also includes the SD card socket and SPI FLASH circuit.
- – Support Arduino Mega2560 Directly inserted;
- – With Full-angle IPS TFT panel;
- – OnBorad level conversion chip for 5V/3.3V MCU;
- – Compatible with 3.3/5V operation voltage level;
- – Compatible with Arduino-Series development Board;
- – Compatible with UTFT / UTFT_Buttons /Utouch Library for Arduino.
- – Provided 12-examples with Arduino, 3-examples with STM32;
- – With SD Card Socket;
- – With SPI FLASH circuit;
